Register Now

Squid90 · 04-28-2014, 03:22 AM

I have a dead Tarot ZYX-S won't power on, no response at all when power is applied. Is there a way to check what part of it died in particular?

jbilliter · 04-28-2014, 07:02 PM

I have a bad one too, although mine powers up and drives servos max. I would open it up and inspect the solder joints to the board where the connectors are, especially the esc plug, for obvious cracks or ability to wiggle the pins. Look at all the solder joints, and clean off any foreign material. I think you will be lucky if you see the problem though.

04-28-2014, 03:22 AM	#1 (permalink)
Squid90 Registered Users Join Date: Apr 2011	Tarot ZYX-S dead (Diagnostics) I have a dead Tarot ZYX-S won't power on, no response at all when power is applied. Is there a way to check what part of it died in particular?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-28-2014, 07:02 PM	#2 (permalink)
jbilliter Registered Users Join Date: Feb 2012	I have a bad one too, although mine powers up and drives servos max. I would open it up and inspect the solder joints to the board where the connectors are, especially the esc plug, for obvious cracks or ability to wiggle the pins. Look at all the solder joints, and clean off any foreign material. I think you will be lucky if you see the problem though.

Register Now

Log-in