Register Now

Bill Fleming · 01-06-2015, 10:44 PM

I have attempted to install two different NAZA-H and now an Icon in my Align 600. All three units were new. I have looked for something they all all have in common, but the computer and transmitter are the only things I can think of, except me of course. I am convinced it isn't me as I am a experienced RCer and I feel qualified for this task, but I'm ignorant on this issue and really need some help. Here is the problem: I can setup receivers, and BECs and accomplish binding . However, when I insert the FBL units into these mockups, none of them have passed a signals to the servos. The servos are receiving power as are the units and receivers. Both installation software and their drivers appear to be loading properly. My transmitter is a JR XP8103. Servos are digital.

The NAZA units have been returned due to DJI not providing any assistance whatsoever, but I'm going to hang with the Ikon until I get it.

Bill

04fxdwgi · 01-07-2015, 03:39 AM

Tried to help you in your other post in the Stabilization forum.

Bill Fleming · 01-08-2015, 08:58 AM

The problem was with the computer. Sorry for any trouble I caused anyone.

Bill

fhu667 · 01-08-2015, 09:53 AM

I would think one of the first things to ask is if you have the Ikon software opened, and you have chosen the receiver type you are using.

01-06-2015, 10:44 PM	#1 (permalink)
Bill Fleming Registered Users Join Date: Jan 2008	Can anyone solve this puzzle? I have attempted to install two different NAZA-H and now an Icon in my Align 600. All three units were new. I have looked for something they all all have in common, but the computer and transmitter are the only things I can think of, except me of course. I am convinced it isn't me as I am a experienced RCer and I feel qualified for this task, but I'm ignorant on this issue and really need some help. Here is the problem: I can setup receivers, and BECs and accomplish binding . However, when I insert the FBL units into these mockups, none of them have passed a signals to the servos. The servos are receiving power as are the units and receivers. Both installation software and their drivers appear to be loading properly. My transmitter is a JR XP8103. Servos are digital. The NAZA units have been returned due to DJI not providing any assistance whatsoever, but I'm going to hang with the Ikon until I get it. Bill

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-07-2015, 03:39 AM	#2 (permalink)
04fxdwgi Registered Users Join Date: Sep 2014 Location: Eastern North Carolina	Tried to help you in your other post in the Stabilization forum.

01-08-2015, 08:58 AM	#3 (permalink)
Bill Fleming Registered Users Thread Starter Join Date: Jan 2008	The problem was with the computer. Sorry for any trouble I caused anyone. Bill

01-08-2015, 09:53 AM	#4 (permalink)
fhu667 Registered Users Join Date: Aug 2013	I would think one of the first things to ask is if you have the Ikon software opened, and you have chosen the receiver type you are using.

Register Now

Log-in