Delayed Throttle Curve

[-רחל]

Ocasionally I'm flying a Blade MQX which seems to have a undocumentated OCP (motors shut down when I quickly push the throttle stick from dull to full).

I've set a 0.7sec delay to a 3 point throttle curve which works fine but I'd like to have the delay working from point #2 to #3 only and not the whole range from #1 to #3
How can I work this out?

[psylence519]

My MQX did the same thing, all I did was limit my throttle curve to not exceed 90% and I could slam it around as much as I want. Have you tried that?

[-רחל]

Been there done that
I had to limit it to somewhat 40% - 50% to avoid OCP, but with this setup it lacked also 50% of the motor performance. I have to admit I use top notch 40C Lipo batteries that may deliver some more Amps than the Eflite stuff.

[psylence519]

Yikes, that's no fun. Good luck figuring it out!