Is this normal for spoolup

[AusAnt]

Is this normal for spoolup? Any ideas what could be wrong?

I setup my radio and Vbar gov as per the manual and Fredrik's vids and other threads. My throttle bottom endpoint ended up at -108 to get lowest possible value with no delay. Max throttle is 94 (as close as I could hear for a dip in rpm). In the vid I put the tx in the frame so you can see me flip TH into a flat TC of 65%.

This is just on a small 6s pack, so it's possible that the low voltage is causing a problem, I just don't have any 14s packs soldered up yet - could that be the problem?

Cheers,
Ant

http://www.youtube.com/watch?v=piccd...ature=youtu.be

[MrMel]

Yup, 6s is too little for it to spoolup properly with that motor.

Been there, done that.

[AusAnt]

Thanks Fredrik, I had better solder up a 14s pack for testing then.

Cheers,
Ant