Register Now

june8781 · 04-07-2009, 08:29 PM

I bound up my dx-7 to my cpp2 and set up the pitch and throttle curves, swash, etc. but I cannot get the throttle to work. I tried rebinding, also reversing the throttle channel, but the esc light stays red. I have the throttle hold set to inhibit, and have no other ideas what could be wrong. Any ideas?

9sec240 · 04-08-2009, 12:32 AM

Turn your throttle trim down about half way till your green light comes on.

june8781 · 04-08-2009, 01:44 PM

thanks I'll try that and report back.

june8781 · 04-08-2009, 10:13 PM

That did it, the pro 2 flies good with the dx7, and it does have quite a bit more adjustment than the stock tx. Thanks again

04-07-2009, 08:29 PM	#1 (permalink)
june8781 Registered Users Join Date: Feb 2008	cp pro 2 w/dx-7 nothrottle control I bound up my dx-7 to my cpp2 and set up the pitch and throttle curves, swash, etc. but I cannot get the throttle to work. I tried rebinding, also reversing the throttle channel, but the esc light stays red. I have the throttle hold set to inhibit, and have no other ideas what could be wrong. Any ideas? __________________ Mike Hurricane 550 cf fes and beasted

04-08-2009, 12:32 AM	#2 (permalink)
9sec240 Registered Users Join Date: Feb 2009	Turn your throttle trim down about half way till your green light comes on. __________________ Ivan

04-08-2009, 01:44 PM	#3 (permalink)
june8781 Registered Users Thread Starter Join Date: Feb 2008	thanks I'll try that and report back. __________________ Mike Hurricane 550 cf fes and beasted

04-08-2009, 10:13 PM	#4 (permalink)
june8781 Registered Users Thread Starter Join Date: Feb 2008	That did it, the pro 2 flies good with the dx7, and it does have quite a bit more adjustment than the stock tx. Thanks again __________________ Mike Hurricane 550 cf fes and beasted

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register Now

Log-in