START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Futaba Radios and Electronics Futaba Radios, Gyros, Servos, Etc. |
|
LinkBack | Thread Tools | Display Modes |
12-21-2011, 04:15 AM | #1 (permalink) |
Registered Users
Join Date: May 2007
|
10 CHG Assigning switch for nav lights
Hi , l have 10CHG radio and can someone help me, l am running a 7Ch R617FS Rx, and l am using ch7 on rx to operate my nav lights, l am having problems to assing ch 7on rx to a switch to make it operate to allow me to turn the nav lights on and off, is it possible,
Regards Dave
__________________
Trex 550E FBL Mini V Trex500 AH-1 Cobra Futaba 10CHG Phoenix |
Sponsored Links | |||
Advertisement |
|
12-21-2011, 06:45 AM | #2 (permalink) |
Registered Users
Join Date: Apr 2010
|
Check if the governor function is active. That could be the reason for your problems.
Then just set a switch to control ch 7. Think it's under auxilary channels. It should definately be possible if the nav lights can be switched on and of by a channel.
__________________
MA Fury 55 FBL Cgy 750 Next D Rave 450 Futaba 520 Align 450 Pro FBL Microbeast Futaba 8FGS |
12-21-2011, 04:39 PM | #3 (permalink) | |
Registered Users
Thread Starter
Join Date: May 2007
|
Quote:
Davo
__________________
Trex 550E FBL Mini V Trex500 AH-1 Cobra Futaba 10CHG Phoenix |
|
12-24-2011, 05:14 AM | #4 (permalink) |
Registered Users
Join Date: Apr 2010
|
Go in to the servo monitor and check the output to the channel. You might have to reverse the channel if you are using a 2 pos switch. Check your endpoints too. Should be at 100.
You are shure the lights are switchable?
__________________
MA Fury 55 FBL Cgy 750 Next D Rave 450 Futaba 520 Align 450 Pro FBL Microbeast Futaba 8FGS |
Thread Tools | |
Display Modes | |
|
|