g20 need help with fuel line and gov sensor

[wc_wickedclown]

yiou can see my problems in this video i hope some one can help me.

should i cut the copper lines down ?
should i buy a spek gov sensor to run the gov from the skookum gyro

and it seems im missing something from the fuel tank to keep the fittings and rubber to hold

i have the over fill hose connected to a outlet on the carb should i just let the hose hang ?

century radical g20 rc helicopter help fuel line and gov sensor question (5 min 9 sec)

[MotorRotor]

Did you buy it new? That is not the same fuel stopper as I and others I know have on theirs.

Also is that the stock tygone fuel lines?

The tubes inside should be fine as long as the clunk does not touch the far wall and is free to move around.

[wc_wickedclown]

Originally Posted by MotorRotor

Did you buy it new? That is not the same fuel stopper as I and others I know have on theirs.

Also is that the stock tygone fuel lines?

The tubes inside should be fine as long as the clunk does not touch the far wall and is free to move around.

no the green fuel line supports unleaded petrol
has the black fuel line on the clunk line

and thank you i figured the fuel stopper was not like the others id seen online ill replace it

[MotorRotor]

Originally Posted by wc_wickedclown

no the green fuel line supports unleaded petrol
has the black fuel line on the clunk line

and thank you i figured the fuel stopper was not like the others id seen online ill replace it

As you indicated that you did not buy it new the fuel stopper system may not be stock. That said, the type you have may well work OK if the bung is made for gasoline. You will note that the single screw is there to screw tighter after the fuel tubes are inserted. This will expand the bung on the inside to seal the bung and prevent it from sliding out.

[wc_wickedclown]

Originally Posted by MotorRotor

As you indicated that you did not buy it new the fuel stopper system may not be stock. That said, the type you have may well work OK if the bung is made for gasoline. You will note that the single screw is there to screw tighter after the fuel tubes are inserted. This will expand the bung on the inside to seal the bung and prevent it from sliding out.

ive noticed that there is 2 fuel inlets on the motor and only 1 in and 1 out on the tank]

i believe there should be 3

[Dennis P]

If you look at the back of the bung there is an extra hole there you just have to push through to open up the third hole on the bung.

[wc_wickedclown]

Originally Posted by Dennis P

If you look at the back of the bung there is an extra hole there you just have to push through to open up the third hole on the bung.

yep thank you

[monroycedric@gmail.com]

Hi

I have a Zenoah 20 Ei for the radikal 20 but the carburetor its not the ones that its in the Century webpage its like the one that you have and i don't know how to connect the lines
can you put more photos to see how its connected to the fuel tank

Thanks!!

Cedric