CNC Tail for Shogun V2

[angeljr]

Any clue as to where I could get one?

[hall3724]

www.microheli.com

[clear4takeoff]

Try the monstrosity from XMseller on Ebay. The last one sold for 36.00. Check out my gallery. It has a 3mm shaft, weighs over an ounce, but fixed all my tail problems once and for all. Make sure to remove and loctite the screws, and you have to cut off I think .280" off your boom because it's longer and has a positive stop.

[futura]

Don't blow your money on that XMseller JUNK.....

If your going to do it, do it right.....the full microheli tail is awesome. I have both the gear drive and belt drive versions. Both are great....I fly the geared drive the most....more efficient and three minute longer flight times because of it....and yes the belt drive is set up perfectly and fly's great too.

[clear4takeoff]

Actually, I tried the Microheli tail setup first...still with the 2mm shaft, it bent in flight and exploded the tail assembly. That's with the tail rotor blades balanced. My machine always had tail vibes. Some V2s just do (there were lots of posts on RR about it). So for me, the Xmseller tail was the only one that worked.

[clear4takeoff]

Actually, I tried the Microheli tail setup first...still with the 2mm shaft, it bent in flight and exploded the tail assembly. That's with the tail rotor blades balanced. My machine always had tail vibes. Some V2s just do (there were lots of posts on RR about it). So for me, the Xmseller tail was the only one that worked.

[Turbo Boss]

Check www.jappausa.com


Isaac

[darkside212]

I'll second that...but I'm biased