Right voltage (built in telemetry in A9) help....

[ljohn82]

Hi,

Im using nicad 4,8v to power up my servo's in nitro heli and i always get the right voltage in my built in telimetry in my optima 7 rx and see it in my tx...

setup is nicad + switch ( heavyduty switch from hitec) connected to channel 7= oks


now i change my setup and add a regulator and 2s lipo can somebody help me to setup/wiring of this, cause i still get 4.8 to 5v my setup is 2s lipo + regulator connected to channel 7 and it appears that my voltage is still same with nicad it suppostedly 7.4v up....

setup is 2s lipo + Regulator + switch ( heavyduty switch from hitec) connected to channel 7 = reading voltage same w/ nicad


anyone know how to get right voltage ? btw i dont use seperate batt in spc....

thanks ( sorry for double post)

[SkyRaptor]

ljohn82, your problem is " btw i dont use seperate batt in spc...."

Since you are using a regulator, you should use the SPC port do power the receiver up directly from the battery. Otherwise you are reading the regulator output voltage, that is suppose to be 4.8V to 5V.

So, power your receiver through spc port and your servos through the regulator. Got it?