A solution to the dreaded setup jumper

[newhelliguy]

Im sure someone else has done this but I couldn't find it anywhere

I have always had problems installing and removing the jumper I drilled a hole in one and attached floss to help remove it but it was still a pain to replace it. On the goblins it is a struggle to insert it. I cut a jumper open to see if I could make a connection that could be connected and disconnected. No luck there. Then I looked at the hole where the jumper was inserted and it looked like a regular servo hole. So I made and extension with a jumper and it works great. No more scratched up hands from placing jumper. If the connector is buried inside the heli eg Goblins I put an extension in permanent and if it is on top I just use an extension instead of the jumper.

.
I made my own servo extender but it is a regular servo extension. For the plug you can use a spectrum bind plug and just move the wire from outside to center, or just cut the extension wires and short them out.

[taosgraveyard]

Great idea.

All of mine are set up this way too.

When I am not programming. I leave a jlog plugged in.
.

[newhelliguy]

taosgraveyard: looks to me like you need an Agile 7.2.

[taosgraveyard]

Tempted...

The only Heli shop in buenos aires is a dealer so parts are available locally