HW 100 Platinum wont arm?

[Scott1115]

I have over 100 flights on this ESC. I crashed last week and needed to swap frames. All electronics look as though they are okay.

I went to test the set-up after rebuilding and the ESC will not arm. i get a beep-pause-beep-pause, etc....

I went back and looked. I THINK I plugged everything back into the vbar as it should be. I have power from the ESC going into the vbar; sbus connection to the vbar from Rx

My guess is that I have to reprogram the end points for the ESC. Not really sure though.

Does this sound reasonable? Any other trouble shooting ideas?

[Pionwave]

Only two beeps and then it's silent?

Have you looked in the manual under trouble shooting? There is a section identifying the beeps for error codes

[Scott1115]

Beep, pause, beep, pause.....etc

Manual says "he throttle signal is irregular, lost, or corrupt. Check the receiver and transmitter.
Check the control cable of the ESC."

Not sure what i am supposed to check on the Rx and Tx or the control cable.

[Scott1115]

Problem solved (I think). Sbus to vbar jumper was not in the AUX channel on vbar.