Warp Wiring Tricks

[HeliKelley]

I took an extensive time trying to figure out how to wire this heli as cleanly as i could. The pictures are attached. I also popped a hole in the battery tray to put the rudder servo through. Im open to questions, if not, Im fine with just showing this off,lol

[ScotY]

Has anyone tried to run the motor wires inside the frame? Is there enough room?

[HeliKelley]

i really dont think so, ive tried and its very close and tight, make working on the elevator servo nearly impossible. i dont mind it being on the outside, doesnt look bad

[Rob43]

I think your wiring job looks the bizness!

Couldn't help noticing how you opted to use your carbon servo arm stiffeners.

[HeliKelley]

im thinking about taking them off but idk, i think they look too cool,lol

[JCLs]

You need to be able to always access motor connectors and no way to get them inside frame with reasonable clearance.


On the iPad again,
JCL

[keither1984]

im running mine inside the frames but I had to solder my motor wires directly to the esc wires for a better fit. here a couple pictures.

[frito169]

Originally Posted by ScotY

Has anyone tried to run the motor wires inside the frame? Is there enough room?

I believe that's how they meant you to run it was inside the frame . There's plenty of room for those small wires