START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Mikado Logo 800 Xxtreme Mikado Logo 800 Xxtreme Helicopters Discussion |
|
LinkBack | Thread Tools | Display Modes |
07-24-2020, 02:58 PM | #1 (permalink) |
Registered Users
Join Date: Jul 2011
|
HK5035 bullet size, vbar firmware
I'm finally putting together a second hand Logo 800 and have a few questions. I need to confirm the size of the motor bullets as I need a set for the ESC side. Previous owner kept the original ESC. The male bullets on the motor measure 5.5mm so do I just buy a generic set?
I going to use an old blueline vbar with external sensor for this build. I recall seeing something about a specific firmware for the logo 800. Any idea where I get this from.
__________________
Goblin 700, Gaui X7, 600EFL, DX8 |
Sponsored Links | |||
Advertisement |
|
07-26-2020, 02:04 AM | #2 (permalink) |
CHC Benefactor
Join Date: Feb 2006
Location: Singapore
|
I had a similar challenge. Can't remember if I had the necessary bullets or had to order. Just measure the length of the connecting portion and get matching females. Worst case order from Scorpion or is that best case?
For the FBL it was a special version of the Vbar. Never heard of it coming as a downloadable firmware. I went with an HC so no issue for me.
__________________
Playing with gravity one heli at a time Dancing with gravity one flight at a time |
09-13-2020, 05:04 AM | #3 (permalink) | |
Registered Users
Join Date: Sep 2011
|
Quote:
__________________
Nothing smaller than 700 ..... |
|
Thread Tools | |
Display Modes | |
|
|