START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Flybarless Helicopter Systems CSM Cyclock, Helitronix Multi-mixer, Spartan AP2000i, Firmtronix Digimix-3, Gyrobot, SK360and AC3X |
|
LinkBack | Thread Tools | Display Modes |
02-21-2014, 06:38 PM | #181 (permalink) |
Registered Users
Join Date: Jan 2014
|
using a fsth9x tx. didnt have any luck trying the gyro in tx mode. cant even get into the swasharf function and the tail would only go one way even trying to set the limits with gyro. maybe i just dont know what the hell im doing but i didnt have a problem resetting the hb800 and setup again letting the gyro have all control . all fine but piro rate
__________________
oxy 3 oxy4 |
Sponsored Links | |||
Advertisement |
|
03-06-2014, 07:54 AM | #182 (permalink) |
Registered Users
Join Date: Jan 2014
|
Ok . Hopfully someone knows the answe to my problem. Ive tried both modes on hb800.lettimg gyro handle all functions and tx mode. I have the heli flight feel to my liking in tx mode. But still cant get full throw from tail servo. Resulting in very slow piro rate. In setup endpoints can be set for full throw but in flight mode the rudder servo wont go to full throw towards tail hub. Anyone have an answer to this problem.
__________________
oxy 3 oxy4 |
03-06-2014, 09:51 AM | #183 (permalink) |
Registered Users
Join Date: Jun 2012
|
can you reset the beastx and do initial setup while your rudder endpoints at normal
THEN go in and turn up your rudder rates in your transmitter?
__________________
XL Power 520 / Spektrum DX6 |
03-06-2014, 12:55 PM | #184 (permalink) |
Registered Users
Join Date: Jan 2014
|
Normal being 100x100 endpoints? I can get a solid tail that way also. But still.the slow piro . Also letting gyro control swash servos wasnot even close to as good as tx mode . It handles really good now. Just gotta figure why im not getting full throw on the rudder.
__________________
oxy 3 oxy4 |
03-06-2014, 02:51 PM | #185 (permalink) |
Registered Users
Join Date: Jan 2014
|
so lowering one rudder end point actually moves the rudder servo center point, the other end point does nothing. dosnt make sense to me but it fixed the problem . just had to adjust linkage rod to rate mode position to match the amount of adjustment to servo center. now it responds to sticks more like my 450 flybarred machine
__________________
oxy 3 oxy4 |
Thread Tools | |
Display Modes | |
|
|