gryphon extreme

[StokemG2]

hello,

thinking about getting the gryphon extreme regulator for my HV Rjx servos and bls251 tail. Specs state 10a/15a piks. Does it provide that current in total or per each servo channel?

[StokemG2]

pls does anyone know the answer to this one? if its 10A on each servo output channel then its plenty for my hv setup but if its 10A total for all 3 HV servo, dont you guys think that a little too little? I thought HV servos could draw more than 20A all together...

i want to buy this unit but not sure if it will handle the HV's

[RasmusDK]

Hi

Go get the quasar, and your good to go :-)

[StokemG2]

i dont really want a bec but rather a regulator so it can regulate my tail servo at 5.1 and HV servos at 7.4. I already have one CC BEC pro. And gryphon extreme seems to do that, i am just not sure if it can handle the amps 3 ccpm HV servos can draw at times. And what will happen if say a servo binds and draws much more amps, does it mean anything above 15A will kill this regulator? i know SGP reactor x even though rated for about same amps but will supply more if needed. Does gryphon do the same or does it burn out if HV servos draw more that 15A all together. Does noone know the answer to this one? Does anyone run HV servos with this regulator?