Heli Acting wierd

[Bornwithatooth]

I'm sure I read about this problem before, but can't remember what the solution was.
My MCPX blades go to full possitive pitch when the heli links to the Dx6i Controler. As I spool it up, it goes to full negative pitch. I believe it's a problem with the heli, not the controler. I've tried rebinding the heli, which is now "Hit and Miss". I've reloaded my controler settings into a different controler slot. Throttle Hold is also not responding.
When I last flew the heli, everything was perfect, but when I went to fly last night, this was happening.
Controler seems to work fine with my MSRX
Thoughts

Born

[Dutchdrifting]

Reverse your pitch channel in the settings on your dx6i.

[Russell Harding]

Make sure you are bound in computer mode. bind using right rudder.

[Dubbin1]

Originally Posted by Code3Medic

Make sure you are bound in computer mode. bind using right rudder.

The right rudder isn't needed with the 6i.

[Bornwithatooth]

Still doing the same thing, and Idle Up is not working either. Will try to bind to a different New MCPX to see if it does the same thing with another Heli

[kona0915]

Originally Posted by Bornwithatooth

Still doing the same thing, and Idle Up is not working either. Will try to bind to a different New MCPX to see if it does the same thing with another Heli

Try creating a new model in a different slot in your TX then bind to that one. Might be that particular one got corrupt somehow

[Bornwithatooth]

I think you're right. I reset the controller, and started from scratch. Now it binds easily, and controlled are working fine.
I did bind to a new MCPX, and it was still not working.
All good now

Born