START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Hitec Gyro/Servos Hitec Gyro and Servo Support |
|
LinkBack | Thread Tools | Display Modes |
02-24-2010, 12:21 AM | #1 (permalink) |
Registered Users
Join Date: Aug 2008
|
Loose Fit With Align's Hitec Servo Wheels
I'm building a T-Rex 700 with Hitec HS-7940TH cyclic servos. The Align servo wheels for Hitec servos have slop in them when installed on the servo output shaft (so I will not be using them). Has anyone else had this problem or did I just get a bad set? I tried an Align JR wheel and an Align Futaba wheel. The Align JR wheel seemed to fit perfectly so I'm thinking that I'll use those. Does anyone see any reason not to? I seems like it should be fine but I'd hate to have the wheel strip under load or something because I used the servo wheels that are for a different brand.
Thanks
__________________
T-Rex 700 LE - T-Rex 600 NSP - T-Rex 500 ESP
|
Sponsored Links | |||
Advertisement |
|
02-24-2010, 12:39 AM | #2 (permalink) |
Registered Users
Join Date: Apr 2007
|
Yeah that is correct Jr servo horns with hitec servos. Align servos aare futuba servos essentially. The out put shafts are splined differently or the O.D. Of the output shaft is different cannot remember or both. Anyway good heads up thinking.
__________________
Full Throttle |
Thread Tools | |
Display Modes | |
|
|