Sk720be talk setup

[flash 56]

Hey guys, I just got around to setting up my other sk720 and have a little problem, in the tail wizard it ask if the rudder in operating the correct way,if not rev. The servo in the software.when I rev. the servo in in the wizard and start to set left travel it constantly tells me it appears the servo is reversed and it won't let me go any farther. The rudder is going in the proper direction. Has anyone had this to happen and what did you do to correct it?

[flash 56]

Sorry it's tail setup , not talk setup, I hate auto fill.

[omerco]

Sounds like you don't have the latest update as this was fixed in the last one.

[flash 56]

Thanks Omerco, I will have to check but I think it's 4.05 now.
before I installed it I updated it, i'll double check when I get home.

[omerco]

I'm referring to software not firmware just to make sure we are on the same page.

[flash 56]

Thanks omerco, I checked when I got home and both were on 4.05, so I tried again and got the same message, so I just went ahead and set it up without the wizard, my other 720bl using the same computer had absoluty no trouble, it's also on 4.05 also. I used the wizard for all the rest of the setup so I wouldn't skip anything. I've read that some were having this issue with an older version and ver.4 was supposed to correct this, so go figure.

[omerco]

Ok then please try doing your stick scaling again. check before that you have nothing reveresed in the Tx.