START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Century Century Helicopters Support |
|
LinkBack | Thread Tools | Display Modes |
11-21-2012, 05:35 PM | #1 (permalink) |
Registered Users
Join Date: Aug 2011
|
Diamond Rotor head..
dose anyone have a 500 600 or 700 Diamond Rotor head?
3,4, or 5 blade? let me know in here or PM me if you do i have some questions about them please.. thanks.. |
Sponsored Links | |||
Advertisement |
|
11-21-2012, 09:37 PM | #2 (permalink) |
Registered Users
Join Date: Aug 2006
|
Hi,
I have a 600 five bladed Diamond Head. You can see it here: https://www.helifreak.com/showthread.php?t=467198 What would you like to know?
__________________
It's easy to find an excuse to do wrong. Hard is not to find an excuse to do right. |
11-21-2012, 10:53 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Aug 2011
|
Hey Jack.. I have some of the grips on order but they arnt gonna be in for awhile cause holidays then weekend and such. Im working on a project, I basically need to know the Dia. of Just the hub and/or the length from the grip tip to the feathering shaft shoulder that screws into the hub. Its 114MM from center of hub to tip of the grip. But, I need to know another measurement for my project.. If I have one of the other two measurements I can figure the 3rd. Would be very much appreciated if you could help me out. Thanks.
|
11-22-2012, 01:06 AM | #4 (permalink) |
Registered Users
Join Date: Aug 2006
|
Is this what you are looking for? Not sure I can measure it precisely...
__________________
It's easy to find an excuse to do wrong. Hard is not to find an excuse to do right. |
11-22-2012, 01:31 AM | #5 (permalink) |
Registered Users
Thread Starter
Join Date: Aug 2011
|
Yes sir. That dimension. I gotta custom make a swash also. Don't have to be exact just as close as you can 1/16 of an inch or so. On the site it's measured in MM nearest MM would be fine to lol. Just whatever you can get
Beep, Beep, Honk, Honk, Over and Out Rotorhead
__________________
Any Landing you can walk away from, is a good landing... |
11-22-2012, 11:28 PM | #6 (permalink) |
Registered Users
Join Date: Aug 2006
|
81.6mm
Good luck on your project.
__________________
It's easy to find an excuse to do wrong. Hard is not to find an excuse to do right. Last edited by jackheli; 11-23-2012 at 01:06 AM.. |
11-23-2012, 12:49 AM | #7 (permalink) |
Registered Users
Thread Starter
Join Date: Aug 2011
|
Thanks man.
Beep, Beep, Honk, Honk, Over and Out Rotorhead
__________________
Any Landing you can walk away from, is a good landing... |
Thread Tools | |
Display Modes | |
|
|