START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
X400 and MX400 Ark X400 and HeliMax MX400 Helicopters Information |
|
LinkBack | Thread Tools | Display Modes |
06-12-2006, 09:32 PM | #1 (permalink) |
|
Futaba T6EXHP Idle up Setup on MX400PRO
I'm quite the newbie and need some assistance here. I've followed the Futaba T6EXHP manual and have combed through the bad grammar (come on Futaba, higher a good translator) and have setup the heli for flight. I've flown it and hovered and it seems right on the money. I have not been able to get the idle up to work. My understanding about Idle up mode is that the throttle is held at one setting and you are only able to adjust blade pitch while flying. Would someone be able to give me a hand? Thanks. Ken.
|
Sponsored Links | |||
Advertisement |
|
06-15-2006, 09:10 PM | #2 (permalink) |
Thread Starter
|
Not a whole lot going on in this forum. I almost feel like the odd ball with an MX400Pro. Regardless, I had a strike of insight or better yet, my brain unfroze and I was able to figure out the setup. I was like, "doh!" set each position on the curve to 100% throttle for idel up! :glasses2:
|
Thread Tools | |
Display Modes | |
|
|