Yge 60 lv v5 problems with ikon gov

[keither1984]

Ok so I've setup several yge esc for ext gov before but never a v5 yge. I think I'm having an endpoint issue. I have the ikon setup 100/100 travel which is 130/130 on the dx8. Problem I'm having is when switching to idle up 2 which is 100 percent throttle on the ikon the motor will stop and I get a 5 beep error. Not sure what to do about this has anyone else seen this issue and have a fix.

[owler]

Yes I have similar issue with yge 60 v5 and Skookum gov on align 450 dominator 6s. It stop in idle 2 3600 RPM (100% throttle). Replaced 11t original motor pinion with 12t. It does help.

[keither1984]

Well I got it to where it won't cut out. But it won't reach my desired heads peed of 3500. It maxes out at 3200. I don't know what else to do. I wonder if there is a new firmware with the v5 that is not getting along with the ikon. Anyone also having this issue?

[keither1984]

Ok figure it out. I hooked ikon up to.my computer instead of tablet and now it goes above 3200. Wonder if that is known with the android software. Any who all seems good now. So strange to set up so many of the same setups and not have this this problem but this is the first yge I have with the built in phase sensor so maybe it's something to do with that.