Using the tuning knobs while flying

[crf250guy]

Hi all,

I mentioned in another post that it would be nice to be able to use the knobs at all times rather than just for programming. I decided to give it a shot and it works great. Just leave one of your programming dip switches on and you can adjust on the fly. The only bummer is if your idle up settings are much different than your normal settings. However, it seems that most people are using the same setting for both. I am currently leaving dip switch #12 on for adjusting mix and gyro sensitivity.

[Dusty1000]

Originally Posted by crf250guy

I decided to give it a shot

I wondered if you would

Thanks for letting us know, will need to try it out!

[kahn10]

old walkera transmitters (and this was a while back) were set up so that the adjustments weren't actually set till the switches had been flipped back and t think the tx powered off......