Warp 360 + VBAR issue

[Ozziffied]

I am having a crazy issue with my warp... when I hover for any amount of time I get a crazy shudder from the cyclic. I have pulled the cyclic gain all of the way down to 42 and it still seems to happen although not that often anymore. However it is still happening. I am going to try and double up on the 3M tape and see if that helps but does anyone have anymore ideas?

[fjoe]

Ground your boom? Lube your belt? Could be static.

[Ozziffied]

Originally Posted by fjoe

Ground your boom? Lube your belt? Could be static.

That's an idea! I will try that tonight and see how it does tomorrow.

[dannylightning]

if you get static the servos will jump all over the place. i saw my friend walk across the carper and pick up static electricity than touch the v bar and all the servos jumped.

i just spray the belt with silicon spray, i have not had any static issues. i have the beast x on mine..

[Ozziffied]

Originally Posted by dannylightning

if you get static the servos will jump all over the place. i saw my friend walk across the carper and pick up static electricity than touch the v bar and all the servos jumped.

i just spray the belt with silicon spray, i have not had any static issues. i have the beast x on mine..

I grounded the boom and it was still happening.... I finally swapped servos to a brand new set of DS95s and it's all gone!! Was a bad set of servos causing it.