Total G not binding.. DSMX 9303?

[antennaman]

Hello all,

Just purchased a JR 9303 2.4H which has been upgraded to DSMX. I have previously bound my DX7 with my total G (which I never finished set-up due to TX getting stolen). I am not able to bind. It goes through the whole flashy process and seems to bind, but when I move the sticks, it appears it has not actually bound - no movement. Could it be my satelite positions? or perhaps that it wont bind to my updated TX? Any input greatly appreciated! Thanks in advance,


Rick.

[antennaman]

I just switched some of the connectors for the satellites(which I thought the rear port was for the rear-most sat..) and it bound...for about 5 seconds. Went crazy then wouldn't respond after power cycling. Most recent updates and all. I can't even walk through the set up process without it going nuts-o.



Seriously.... If no one can offer any helpful advice, I am about ready to go out and buy a shotgun JUST to blow this thing up. I have literally spent hours trying to program it. I am not an idiot. I can follow directions...

Maybe I'll just buy a 3GX or Beast X and supporting equipment.

[Tommy Wagner]

Make sure that the total g is set to jr for tx type. Do not hook up any of the servos and do not use the top port to power the unit unless you are using a battery less then 5.1 volts.

Also the rear most sattlelight is the main one

[CF_Machete]

Has your t-g had the dsmx upgrade, if not, set your tx to dsm2.