How to balance charge using cellpro PL8

[bemyself]

Hi,
Tried searching but dosen’t comes up with anything. How all of you PL8 owners balance charge your battery?
For me, I use high power connect my 6s 5000 mah in parallel with the balancing tab plug into the balancing board and the battery dean plug into the balancing board dean plug. After the charger sound off as fully charged, my 2 packs of 6s read 4.21, 4.16, 4.18, 4.2, 4.15 and 4.2. Both packs have quite similar reading. Seems like it’s not balance charged at all. Am i doing the correct way? Please advise.
Thanks

[pctomlin]

You need to use the Accurate charging mode to balance the cells to an equal voltage. I have my main mode that I use as Accurate charge set for 2C charge amps.

[bemyself]

Originally Posted by pctomlin

You need to use the Accurate charging mode to balance the cells to an equal voltage. I have my main mode that I use as Accurate charge set for 2C charge amps.

Hi Paul,
Thanks alot or the infos. Yes, I was also advised what you had told me. I’m going to give it a try. Thanks once again.
Regards.

[bemyself]

Hi Paul,
Just a update. Accurate charging is the way to go. It charges way better the high power. Thou it’s not of the same voltage readings on every cell but it’s close and much better. Thanks.