Register Now

cliff600 · 03-19-2012, 02:03 PM

I just bought a used Raptor 90 and the collective pitch arm seem to have alot of slop in it. Is this normal? Is there something I can tighten or replace to get rid of the slop?

TTRAPTOR903D · 03-19-2012, 03:01 PM

Check the bearings at the pivot . There is also a collar that goes aroun the bolt through the bearing that I have seen people leave out. Did you get a manual?

cliff600 · 03-19-2012, 04:05 PM

No, I didn't, but I think I found it and fixed it. The pivot piece was loose, it was wiggling all over the place, and it was only those two nuts holding it in there. It all seems really tight now, so I guess I will try it.

03-19-2012, 02:03 PM	#1 (permalink)
cliff600 Registered Users Join Date: Nov 2005	Raptor 90 SE problem I just bought a used Raptor 90 and the collective pitch arm seem to have alot of slop in it. Is this normal? Is there something I can tighten or replace to get rid of the slop? __________________ Where does the white go when the snow melts?

03-19-2012, 03:01 PM	#2 (permalink)
TTRAPTOR903D Registered Users Join Date: Sep 2009	Check the bearings at the pivot . There is also a collar that goes aroun the bolt through the bearing that I have seen people leave out. Did you get a manual? __________________ *700N DFC* 3GX OS91HZR *700E DFC IKON* KDE XF700-505 CCHV160 *600E PRO 3GX* *450 PRO 3GX* KDE BLING *RAPTOR 90 3D* OS91HZ *1ST HELICOPTER*

03-19-2012, 04:05 PM	#3 (permalink)
cliff600 Registered Users Thread Starter Join Date: Nov 2005	No, I didn't, but I think I found it and fixed it. The pivot piece was loose, it was wiggling all over the place, and it was only those two nuts holding it in there. It all seems really tight now, so I guess I will try it. __________________ Where does the white go when the snow melts?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register Now

Log-in