titan x50e need info

[daveiga2005]

need pics of some wireing im running beastx and with it in the back my servos don't reach and is there any other place were i can put the beastx.im using all servos and ecs,motor from a trex 600 efl thanks for any info

[charliejjr]

I mounted mine in the back and you will need a couple of servo extensions to reach it.
My son mounted his up front on the side of the frame and I believe he had to use a couple of servo extensions also. Here's a couple of pictures. Hope this helps you out.

Charlie

[daveiga2005]

thank. how do you like the x50.im coming from the trex600 efl.and aare you runing 12s.and wats a good headspeed for this heli doing mild 3d.thanks again for the pics

[charliejjr]

See this thread. I posted my setup there.

https://www.helifreak.com/showthread.php?t=426433

Charlie

[daveiga2005]

i think im going to mount it on the side.and i checked out your post thanks

[raptorz499]

I mounted mine right on the front tray laying flat as close to the servos as possible...works great.

[daveiga2005]

raporz499 i was thinking the same thing.are you running a beastx?and how is the tail holding being that far from the main shaft.

[raptorz499]

Solid as a rock bud! I can send you a picture if you like? I have the esc sideways in the front tray and the lipo forvthe electronics where the esc "should be"
Pm me your email address and I can send picture

[daveiga2005]

Pm sent.I'm using the Bec pro that's connects to one of my 6s lipo.I'm running the tp 3850 65c x2 i think it saves a little weight.this is the set up i was running on the trex600 efl I'll post pics when I'm done with the build.thanks to everybody that posted to help me out heli freak #1 can't wait to get it up and going.now i need to know watt its a good headspeed for doing mild 3d thanks again everybody for the help