 |
START HERE |
|
| Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
|
|
|
Unregistered
|
||||||
| Hitec Gyro/Servos Hitec Gyro and Servo Support |
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
04-01-2011, 09:23 AM
|
#1 (permalink) |
|
Registered Users
Join Date: Jan 2011
|
Good gyro with the HSG-5084?
Any recommendations on a gyro to go with the HSG-5084? I'm flying a Blade 400. I'm still fairly new and not into any hardcore 3D. I'm looking for a gyro that's consistent, reliable, has a relatively painless setup, and is under $200. Thanks.
Dan
__________________
Blade 400 - HS-5065MG x3, HSG-5084, Futaba GY520, SportBEC | DX8 mCP X - Extended | DX8 |
|
|
| Sponsored Links | |||
|
Advertisement |
|
||
|
04-20-2011, 01:52 AM
|
#2 (permalink) |
|
Registered Users
Join Date: Jan 2010
|
Friend,
I see u are using gy520 with the 5084. How was the performance of the combo? Looking for a gyro for my 450 too. Thanks |
|
|
|
|
04-20-2011, 02:23 AM
|
#3 (permalink) |
|
Registered Users
Join Date: Apr 2008
|
I've run a Spartan DS760 and Quark with that servo and it's been a great combo.
A new Quark (DS760's discontinued) would sit slightly above your $200 mark, but they can be picked up second hand no worries with guys going FBL. Painless installation and great performance.
__________________
450 PRO, 500 ESP Due to economic circumstances, the light at the end of the tunnel has been turned off until further notice. |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
