Wtb gv1 sensors

[tonyd12]

Wtb gv1 sensors new or like new

[cmulder]

i found this after also trying to hunt down a gv1 sensor case since they deteriorate after about a decade of exposure to fuel.


apparently they are just 2 parts and found this very old post

TJ and GV-1 can be readily built from Digikey (http://www.digikey.com) part number DN6852A-ND if you want the same sensitivity, or part number DN6848-ND for a more sensitive sensor (it will allow more than a 2mm gap between sensor and magnet).
You will only need to solder the terminals to a servo cable and isolate them with heatshrink.
Black or Brown wire - Ground - goes to the centre terminal on the sensor
Red wire - Positive - goes to left terminal, when looking at the sensor from the label side.
White or Orange wire - Signal - goes to the right terminal, when looking at the sensor from the label side.
For a GV-1 you need to put a 1k Ohm resistor across the signal and positive wires.

[cory r]

I have one....

[Gasbag]

I have an optical sensor if your interested. Been working with my GV1 for years
( no need for magnet )

[cory r]

Is this what you need? $30...