"No data in file"?

[npomeroy]

I changed the logging from vibration to playback (see config file), and flew for 1.5 minutes. The playback says there is no flight data. It was well over 15 seconds.

Any ideas?

Nelson NZ

[taoY]

For playback log, you need to wait few seconds to unplug the power after landed. Normally, I wait until the CC ICE beeps (about 20 seconds).

[georgi UK]

=] yes, the SK needs time to finalize a recording and must be still also for that duration.

[npomeroy]

Originally Posted by gmcallister

=] yes, the SK needs time to finalize a recording and must be still also for that duration.

Yes I know that. I tried again today. Approx 1:15 min flight. Waited 15 seconds after rotor stopped turning on ground. 428 KB file - still no flight data. Are there other causes? I used to do lots of these and didn't have a problem.

[georgi UK]

=] Nelson hi, could be you need to make some room on the SD card, delete files no longer needed. the card itself could be going bad?

check out the SK wiki to view the cards memory =

http://www.skookumrobotics.com/wiki/...in_Flash_Drive