Nano down

[ashikoman23]

I'm having bad luck this week. The other day the esc fried on my bl nano. Then today I think the board went on my stocker. It binds fine but the main motor cuts in and out. I've replaced it, but still the same. Tail motor starts, main motor starts then cuts out. It does this a few times then will fly for a minute or so then drops again.

[Johntomk]

I had the same problem with mine cutting off just after spooling up or while spooling up. This is a pretty common problem with the board. Try binding your heli again just to make sure that isn't the issue. I just got my repaired board back from megasmicros yesterday. Mine started acting up as soon as I finished my double bl conversion from astroid designs. Needless to say I'm ready to get it going again. You say you "replaced it". Are you referring to your esc, motor or main board? You might think about upgrading to an astroid conversion. If you do not want to do that, I would at least replace the esc with an xp3a or mx3a. The HH bl esc seems to give out pretty easily. At least that iis what it seems like from reading the forums.

[ashikoman23]

I replaced the main motor in the stock nano. The bl is a mild from astroid. The xp3a burned up because of a bad battery connector I think. Stock board will be off to megas next week. Does anyone know average turnaround time from him.