Need help belt cpx with turnigy 9x

[kilcrease58]

Hey guys I'm some what newer to flying helicopters been flying for the last 3 years off and on and I have finally met my match with this combo here is the problem. I have installed my new receiver and set up/binded my turnigy 9x to my Belt cpx everything seems to work great hovers good holds its tail nicely but will not roll left or right ? I'm not sure what settings are wrong here the servos are moving correctly I believe? What is my fly bar supposed to do when I try to roll side to side? Everything is hooked up right I think. any help will do.

[jperkosk]

Hi, welcome here on Belt CP forum. Without more details it's kind of hard to give you a specific advice, but basically the swashplate should follow your cyclic commands: pushed forward the swashplate should tilt forward, rolled right it should tilt right.

It sounds as if you have aileron channel not set-up properly, although it could be a few other things as well. Some more details, or maybe even a short video clip?

[kilcrease58]

Thanks jerry, my swash plate looks like its moving fine it has good range of motion and all servos are responding as you described, but the helicopter doesn't really responed to left/right crlyic inputs while flying it flew great with the stock tx it ! The fly bar rotoates the paddles up and down when I try l to roll to either side if this helps