CGY750 questions

[k4rn1v00l]

Setup is Titan x50 with OS55 on 14sg
1. How is everybody running there power?
Y-harnesses into control amp and into the Rx? Seems odd all the servos will be fine running off the sbus cable if the battery is plugged in the Rx. I want to have it split 3 ways off the 2s lipo and run a lead to the Rx and y-harness into the cgy on any 2 cyclic servos
2. What head speed to trim in?
3. I set the thr end point to 100 and adjusted the linkage on the carb to be fully open then adjusted the low end point to have it idle which came out to like 85. Is this ok?
4. Also can I use a different tail servo other than a bls251 like a RJX HV tail servo it has a 760 pulse width as well
5. When setting the sws.rate I have 75% at 9.5° but 8.5° the other way. I kno a degree off isnt a big deal but do you use the low side or the high side to set sws rate
6. Same with the pitch. I have 13.5° positive at like 65% and negative was like 12.8° I just used the pitch end point to match. It came out to like 107. Is that ok?

Appreciate any input!

[ttrip06]

1. I plug the power directly into the 750 and let the sbus cable carry it back to the rec.

2. Trim in the head speed you will use the most.

3. yes that will be ok, but if you continue to fuss a little more you can probably clean that up to 93/93.

4. Not sure on the tail servo, but I don't see why not.

5. That is typical with a cgy 750 to see a difference from side to side. See DChekas response in this same forum.

6. Same as above.