T14sg - Hc3sx via Subs

[Goldenhour]

No matter how I configure Throttle hold I get mixed with the helicommand, channel 7. With the 10chg and the standard Rx setting up was a breeze. Something about the Sbus I think. I've INH Ail. and Ele. in the Gyro page leaving the Rudder with gain.
What fun, down time.

[Smith T]

Golden, I have a 14SG with a BD3SX on a couple of Helis. I am traveling and will not be home until Saturday so I do not have my radio in front of me. When you say your hold mixes with channel 7 what are you seeing. What do you have channel 7 assigned to in the radio and HC. The Sbus and RX connections act the same other than just having one wire.

[Raptorapture]

I'm also on the road but hopefully can help a bit. Channel 7 if I remember correctly can be set up for either the head gain or bailout and self level. Tail gain if set to be adjustable should be on channel 5. S.BUS should have no impact on signal received from Tx by HC for all channels. In fact, now that I think about it S.BUS must be required to get all the other channels to HC. TH should only be causing channel 3, the throttle channel to go to about 27 or so. Open the servo output screen on the Tx and see if anything else moves when you hit TH. Sometimes the switch that you use for TH is also assigned for something else or there may be something else configured in the TH screen(s).

[Goldenhour]

Thanks to all the help that came my way. I need to pay back and at least make a video of what was holding me up. So someone else may benefit from my ignorance.
In a nut shell....
On the function screen where you assign switches to functions.....
Well with the 14sg you can select or change the function as well as the switch assignment. My last four transmitters this was not the case.
Wow when I found that out. It all works. Now for a day without rain.