01-21-2008, 01:36 AM
|
#21 (permalink)
|
Registered Users
|
Quote:
Originally Posted by HeliBouncer
So how do you get this gyro to reconize a DX7? I ran through the setup phase where you turn on the transmitter with the rudder to the full left/right with the receiver already powered on and now the servo only moves to right rudder input. No matter what percentage 0-50 set in the transmitter, the rudder input only moves the servo barely.
Any ideas or solution? Thanks
|
Put your rudder endpoints to 150 both ways for the setup to recognize, cheers.
__________________
...Once upon a time there were Nitros, flybars & frequency pins...Shawn
|
|
|