NCPX will not bind to NEW DX6i!!!!

[strtbobber]

Originally Posted by ronj

Yup, looks like the DX6i is the problem. That seems unusual, they are usually pretty good out of the box. Hope you can get a replacement real soon.

Thanks!! I hope REAL soon too! I'll update as soon as I hear from the hobby store.

[strtbobber]

Well, I exchanged my tx yesterday. FINALLY got to do some flying last night. Everything works great!

Even the hobby store couldn't believe when I showed them that the aileron channel was not functioning. I've bought quite a few radios in my time and this one takes the cake.......it's the weirdest thing.

Oh well.........I'm back up!

[abean70]

I had a problem with binding to my DX7. The all in one light would sit and flash in bind mode. What finally fixed it for me was making sure the throttle curve could go below zero... I set it for -1, that way my minimum throttle was sure to be zero. No more binding issue.

[godp1301]

Mine wouldn't bind anymore because of a crash. I ordered a new board and I couldn't bind it either. I followed the manual's instruction on binding with a computerized tx and couldn't get it to work.

What worked for me: Switching the Dx6i on with the binding switch on and not releasing it nor giving right rudder. After about 15 seconds the nano binds. I have tried this several times and it seems it's the only way I could make it work....

[fishsticks]

I bought a new 3 in 1 and it would not bind to my 6xi as well. I tried almost everything. Finally a HH representative told me to connect the battery to the heli, turn the tx on while holding the bind switch for a few seconds while holding the left stick in the lower right position, releasing the bind switch while holding the left stick in position. It worked!

Apparently some 3 in 1 boards are bound to a non computerized tx at the factory and will not bind to a computerized radio unless you do the above procedure.