START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Kontronik Drives Jazz and Jive ESC's and other Kontronik equipment support |
|
LinkBack | Thread Tools | Display Modes |
05-14-2015, 08:42 AM | #1 (permalink) |
Registered Users
Join Date: Aug 2013
|
Jive 100 LV dead?
I flew one flight all was well. I plugged in my next pack things came on for a moment and shut off. I get no beeps, blinks nothing. I'm using both BEC leads and when use another rx pack everything powers up fine. Should I send this in for service?
|
Sponsored Links | |||
Advertisement |
|
05-14-2015, 08:49 AM | #2 (permalink) |
Registered Users
Join Date: May 2011
|
can you give us some more details as far as your whole setup goes? servo fbl unit wiring motor etc.
__________________
Richard Zappe Team Kontronik USA PeakAircraft |
05-14-2015, 09:00 AM | #3 (permalink) | |
Registered Users
Thread Starter
Join Date: Aug 2013
|
Quote:
Logo 550sx Savox SC 1257 TG Savox SH 1290 MG Mikado Scorp motor master and slave connected Pulse 5000s Vbar Neo (used to be mini) This is not new this year I flew it last year as well. This was after my 5th flight this year. |
|
05-14-2015, 10:17 AM | #4 (permalink) |
Registered Users
Join Date: May 2011
|
But the neo is new correct?
__________________
Richard Zappe Team Kontronik USA PeakAircraft |
05-14-2015, 11:09 AM | #5 (permalink) |
Registered Users
Thread Starter
Join Date: Aug 2013
|
Yes. And it still works when I power it with another nimh or another BEC. This would have been the Neos 3rd flight.
|
05-14-2015, 11:19 AM | #6 (permalink) |
Registered Users
|
even if your TC isn't sending 0 to arm the ESC you'll still get BEC power. If you aren't getting any voltage out of the BEC then it's a service call. I'd take a volt meter and check the pos / gnd on both master and slave.
__________________
DX9, Mostro 700N 120SRX, HD Cell 500, Blade 450xl 6S, 180 CFX and 130x. |
Thread Tools | |
Display Modes | |
|
|