Register Now

Rick Rotorhead · 11-04-2006, 08:11 PM

Hi all, one of my boys pulled the cable off my Fut 9c Tx - it looked ok but when I tried to fly the heli was stuttering in all axis. Called up the channel display box, and it showed all tx controlls twitching like crazy! After wiggeling and bending the cable at the Tx plug it went back to normal, for a few seconds. So I think its now got a bad connection or broken wire near, or in, the square Tx plug. Question is, can I cut it open and re attach the wires or does it mean I gotta buy a new cable?

Gary JP4 · 12-21-2006, 08:50 PM

You can just open it up and reconnect on the old style. I think they were of that type from what I have read. I have the new molded style. If you have that you would have to cut off and get a new jack. Or just send it back they say they will replace for free.

11-04-2006, 08:11 PM	#1 (permalink)
Rick Rotorhead Join Date: May 2006	bad connections at Tx plug Hi all, one of my boys pulled the cable off my Fut 9c Tx - it looked ok but when I tried to fly the heli was stuttering in all axis. Called up the channel display box, and it showed all tx controlls twitching like crazy! After wiggeling and bending the cable at the Tx plug it went back to normal, for a few seconds. So I think its now got a bad connection or broken wire near, or in, the square Tx plug. Question is, can I cut it open and re attach the wires or does it mean I gotta buy a new cable?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-21-2006, 08:50 PM	#2 (permalink)
Gary JP4 Join Date: May 2006	You can just open it up and reconnect on the old style. I think they were of that type from what I have read. I have the new molded style. If you have that you would have to cut off and get a new jack. Or just send it back they say they will replace for free.

Register Now

Log-in