Register Now

bobblehead · 05-28-2014, 08:58 PM

I'm struggling assembling the alu. grips, FS, and main rotor hub. Are there two screws on the end of the FS? That's what it shows in the instructions, but I'm only getting one screw off. It makes sense for both screws to come off, to fit both washers. Any advice? Thanks

ThatVWguy · 05-29-2014, 08:04 AM

I clamped the shaft in a small vice between two rubber bands to prevent damage, and then unscrewed the other screw.

bobblehead · 05-29-2014, 12:16 PM

Thanks, problem all sorted out. I used a pair of pliers to get it off. I thought that only one screw came off, just like the stock fs..

05-28-2014, 08:58 PM	#1 (permalink)
bobblehead Registered Users Join Date: Jul 2013	Xtreme DFC Assembly? I'm struggling assembling the alu. grips, FS, and main rotor hub. Are there two screws on the end of the FS? That's what it shows in the instructions, but I'm only getting one screw off. It makes sense for both screws to come off, to fit both washers. Any advice? Thanks

05-29-2014, 08:04 AM	#2 (permalink)
ThatVWguy Registered Users Join Date: Jan 2014	I clamped the shaft in a small vice between two rubber bands to prevent damage, and then unscrewed the other screw. __________________ Nano QX, QX 3D, Nano CPX (HH BL), MCPX BL (Fully MH), 180cfx, Hyper 400 3D, DX8, RF7

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-29-2014, 12:16 PM	#3 (permalink)
bobblehead Registered Users Thread Starter Join Date: Jul 2013	Thanks, problem all sorted out. I used a pair of pliers to get it off. I thought that only one screw came off, just like the stock fs..

Register Now

Log-in