START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Outrage RC Outrage RC - and XP Li-Po Factory Support Forum |
|
LinkBack | Thread Tools | Display Modes |
06-25-2012, 03:08 PM | #1 (permalink) |
Registered Users
Join Date: Jun 2009
|
Hex starter adapter help!
My new velo 50 flybarless kit came with a clamp style hex starter and it will not tighten down on the shaft enough to turn the engine. I see in the manual it is pictured with a set screw which would solve the problem. Did I get the wrong one with my kit? Can not get through on outrage's website customer service. Please help! Thanks
Brian |
Sponsored Links | |||
Advertisement |
|
06-25-2012, 06:04 PM | #2 (permalink) |
Registered Users
Join Date: May 2010
|
I used to fix the Trex 700 starter bullet on my velocity 90. Am not sure but as far as i can remember the v90 & v50' starter bullets are interchangable. So the Align bullet should just work fine on your 50. As i said am not sure so just check for the diameter.
The clamping style is the old type never worked with me either but i remember that shaft and its bullet were revised and there is a better one in the market. Sent from my GT-N7000 using Tapatalk 2
__________________
|
Thread Tools | |
Display Modes | |
|
|