DX7 channels registering low values

[Rªzª]

I just got my copy and had some trouble setting up my DX7. I noticed if I left all the channel endpoints on the radio at -100% to 100% that the sim would not see the full travel. In some cases the sim would only registed about 86%. I properly calibrated and such, but I found I just needed to up the endpoints (in some cases about 120%) on just about every channel to get the sim to register 100% on them... Is this normal?

I'm not just talking about throttle and pitch and such (i.e. curves are not the issue). I'm also talking about ailerons, elevator, and rudder too...

Btw this is 5.04 with the newer red dongle.

Thanks

[Rªzª]

lots of activity in this forum

[Ralf W.]

Hi Raza,

difficult question.When I calibrate the sim and my old futaba tx, I get the result "center position at 1,51 ms" for nearly all channels. The smallest value is 1,44 ms, the largest values are 1,51ms. What do you get with your DX7?

Regards
Ralf W.