tail bounces back

[Scured]

im not sure if this is a 3g issue or an issue with my trex 550 but i dont know why this is happening, ok:

I have a little problem with my tail, when i give left rudder and stop hard the tail bounce back to where it was. but when i give rudder to the other side it stops perfect NO bounce back. i have 3g v2.1 and using those coolice settings for the 550

[Coolice]

Hey buddy.

Glad to hear you're using my settings, apart from the tail bounce back do they feel ok on the cyclics?

I've not seen any bounce back on my own model, but I am running a shorter than manual advised tail servo horn and large heli mode with 30 delay added, which will help.
You might need to try raising the rudder stop gain, this should help with the bounce back. I might even suggest trying the lock gain, in case that's fighting your stops and bringing the tail back.

Out of interest what tail servo are you running? I'm flying a DS620 on my 550.
.

[Scured]

im using the ds620 aswell, other than the tail bounce back everything else seems fine, i will try to adjust the 3g sometime tomorrow