Register Now

Tmblewd · 05-08-2009, 06:07 PM

I finally got my 64 tooth pulley from Germany. I ordred it from World of Heli online. The pulley looks pretty good. It's all ready to be installed in my Lepton. I also ordered the 7mm thick gear. That looks really good too. I also ordered what they call the MAH 68mm tail rotor blades. I think they are copies, but they seem pretty decent. I'm going to get it all installed tonight and hopefully get it out flying tomorrow.

Here are pics, they are the best I could do for close ups.

houstonrevo · 05-11-2009, 08:57 PM

That pulley is high quality stuff. You will notice a big difference in you tail performance. You may want to consider moving in the servo horn to 10.5 mm. If you keep the same setting on the tail, it will wag really bad and you end up turning the gain down back.

Tmblewd · 05-11-2009, 11:19 PM

So I must have gotten my pulley from the same place you did. I haven't had a chance to do anything do to work. All the parts are sitting there waiting to go in the Lepton. I'll try what you said and see how it works. Thanks

05-08-2009, 06:07 PM	#1 (permalink)
Tmblewd Registered Users My HF Map location Join Date: Feb 2007	64 tooth pulley from Germany I finally got my 64 tooth pulley from Germany. I ordred it from World of Heli online. The pulley looks pretty good. It's all ready to be installed in my Lepton. I also ordered the 7mm thick gear. That looks really good too. I also ordered what they call the MAH 68mm tail rotor blades. I think they are copies, but they seem pretty decent. I'm going to get it all installed tonight and hopefully get it out flying tomorrow. Here are pics, they are the best I could do for close ups. Attached Thumbnails

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-11-2009, 08:57 PM	#2 (permalink)
houstonrevo Registered Users Join Date: Nov 2006	That pulley is high quality stuff. You will notice a big difference in you tail performance. You may want to consider moving in the servo horn to 10.5 mm. If you keep the same setting on the tail, it will wag really bad and you end up turning the gain down back.

05-11-2009, 11:19 PM	#3 (permalink)
Tmblewd Registered Users Thread Starter My HF Map location Join Date: Feb 2007	So I must have gotten my pulley from the same place you did. I haven't had a chance to do anything do to work. All the parts are sitting there waiting to go in the Lepton. I'll try what you said and see how it works. Thanks

Register Now

Log-in