Register Now

soupy01833 · 12-22-2012, 02:00 PM

So my brushed main motor spins constantly when plugged into the board. Can i use the small positive signal on the back of the board?

It seems like the negative point does not work. I am thinking it is cause the fet is bad?

Sound ok?

Thanks

vertico · 12-22-2012, 02:41 PM

No, you will need an esc to drive a brushless motor to use that spot.

You might as well get a brushless kit as it is nearly the same price as a new 3in1.

Or send it to megastumbler (megasmicros.com) and have him check out the board. He does amazing work.

soupy01833 · 12-22-2012, 03:15 PM

ok i was not specific. I have a brushless kit set to neg ppm. What i want to do is change it to postive and use the small point on the back. just making sur it is possible

soupy01833 · 12-22-2012, 04:33 PM

Nevermind. I used another 3 in 1 i had and it is working great. This board has a missing resistor on the front. A bad motor fet and I think the pad in the back is lifted. Bought it used so not sure how much was already there.

I will either buy a new board or get this one fixed if someone is up to the task

12-22-2012, 02:00 PM	#1 (permalink)
soupy01833 Registered Users Join Date: May 2006	can I? So my brushed main motor spins constantly when plugged into the board. Can i use the small positive signal on the back of the board? It seems like the negative point does not work. I am thinking it is cause the fet is bad? Sound ok? Thanks

12-22-2012, 02:41 PM	#2 (permalink)
vertico Registered Users Join Date: Jul 2011 Location: Colorado Springs	No, you will need an esc to drive a brushless motor to use that spot. You might as well get a brushless kit as it is nearly the same price as a new 3in1. Or send it to megastumbler (megasmicros.com) and have him check out the board. He does amazing work. __________________ Fusion 180 - M2 Evo - RAW 420 - Fusion 550 - Tron 5.5 - Kraken 580 - Kraken 580n - Kraken 700 - Kraken 700n - Vcontrol Evo

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-22-2012, 03:15 PM	#3 (permalink)
soupy01833 Registered Users Thread Starter Join Date: May 2006	ok i was not specific. I have a brushless kit set to neg ppm. What i want to do is change it to postive and use the small point on the back. just making sur it is possible

12-22-2012, 04:33 PM	#4 (permalink)
soupy01833 Registered Users Thread Starter Join Date: May 2006	Nevermind. I used another 3 in 1 i had and it is working great. This board has a missing resistor on the front. A bad motor fet and I think the pad in the back is lifted. Bought it used so not sure how much was already there. I will either buy a new board or get this one fixed if someone is up to the task

Register Now

Log-in