Register Now

bluealien · 03-13-2005, 11:39 AM

hi all, i have a question... I'm using a phoenix -25 speed controller with my 2025-4200 himax brushless, I've seen combo deals of the himax 2025 being sold with the phoenix - 35. which one is correct?

capebob · 03-13-2005, 06:51 PM

The -25 is adequate for the 2025-4200. It's the one I use. Many are using th -35 because it is claimed that there is less tail wag using this controller. I don't know abut that.

Bob

Kenji · 03-14-2005, 08:58 AM

I too am using the Ph-25 with the himax 20215-4200 and I have no problem. Good Luck

Hotshot Charlie · 03-14-2005, 09:04 AM

Ph25 and 2025-4200 on plank and had it in a Shogun also. Worked fine.

DLWoodie · 05-15-2006, 05:05 PM

I used to use the 25 with that motor and had no problems. Recently I switched to the 35, and had lots of problems with interference that I never had with the 25, it's a common problem in the forums.

Unless you have changed the servo position and tail gearboxes then wag caused by esc is the least of your worries.

darkside212 · 08-24-2006, 07:13 AM

The 25 is perfect for the shogun...the 35 is overkill :rolleyes:

03-13-2005, 11:39 AM	#1 (permalink)
bluealien Join Date: Mar 2005	speed controller question, himax, phoenix hi all, i have a question... I'm using a phoenix -25 speed controller with my 2025-4200 himax brushless, I've seen combo deals of the himax 2025 being sold with the phoenix - 35. which one is correct?

03-13-2005, 06:51 PM	#2 (permalink)
capebob Registered Users My HF Map location Join Date: Apr 2004	The -25 is adequate for the 2025-4200. It's the one I use. Many are using th -35 because it is claimed that there is less tail wag using this controller. I don't know abut that. Bob __________________ Samuel Adams field rep Buffalo Wings field rep Success is the ability to go from one failure to another with no loss of enthusiasm. Churchill

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-14-2005, 08:58 AM	#3 (permalink)
Kenji Join Date: Dec 2004	I too am using the Ph-25 with the himax 20215-4200 and I have no problem. Good Luck

03-14-2005, 09:04 AM	#4 (permalink)
Hotshot Charlie Join Date: Apr 2004	Ph25 and 2025-4200 on plank and had it in a Shogun also. Worked fine.

05-15-2006, 05:05 PM	#5 (permalink)
DLWoodie Join Date: May 2006	I used to use the 25 with that motor and had no problems. Recently I switched to the 35, and had lots of problems with interference that I never had with the 25, it's a common problem in the forums. Unless you have changed the servo position and tail gearboxes then wag caused by esc is the least of your worries.

08-24-2006, 07:13 AM	#6 (permalink)
darkside212 Registered Users Join Date: Jul 2006	The 25 is perfect for the shogun...the 35 is overkill :rolleyes:

Register Now

Log-in