Register Now

rebeltrousers · 07-04-2014, 10:46 PM

Doing a stretch of my Thundertiger G4.1 to 800-size.
Since Edge seem to be out of the picture and SAB are always out of stock which 800 blades are available, and recommended? I'm now down to considering black spinblades (which may be hard to see) and align 780s which won't make the most of the stretch etc.

Any advice would be great!

Cleared2Engage · 07-05-2014, 09:37 AM

http://www.amain.com/product_info.ph...iber-Blade-Set

utrinque · 07-05-2014, 10:25 AM

Check 780mm and 800mm Align blades. I loke them. There are also 810mm RJX assymetrical blades, also decent and good for low RPMs and also 3D. Check also eBay. I got great 800 blades very cheap once.

rebeltrousers · 07-10-2014, 02:44 PM

Thanks!

Found no reasonable blades on eBay that we're stoppable to me in NZ but luckily I found some edge blades in Australia and they're on the way now!

07-04-2014, 10:46 PM	#1 (permalink)
rebeltrousers Registered Users Join Date: May 2009	Which 800 blades and where has stock? Doing a stretch of my Thundertiger G4.1 to 800-size. Since Edge seem to be out of the picture and SAB are always out of stock which 800 blades are available, and recommended? I'm now down to considering black spinblades (which may be hard to see) and align 780s which won't make the most of the stretch etc. Any advice would be great! __________________ Silverline V-bar, Vbar Control #205

07-10-2014, 02:44 PM	#4 (permalink)
rebeltrousers Registered Users Thread Starter Join Date: May 2009	Thanks! Found no reasonable blades on eBay that we're stoppable to me in NZ but luckily I found some edge blades in Australia and they're on the way now! __________________ Silverline V-bar, Vbar Control #205

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-05-2014, 09:37 AM	#2 (permalink)
Cleared2Engage Registered Users My HF Map location Join Date: Oct 2009	http://www.amain.com/product_info.ph...iber-Blade-Set

07-05-2014, 10:25 AM	#3 (permalink)
utrinque Join Date: Feb 2011	Check 780mm and 800mm Align blades. I loke them. There are also 810mm RJX assymetrical blades, also decent and good for low RPMs and also 3D. Check also eBay. I got great 800 blades very cheap once.

Register Now

Log-in