Voltage reading with micro paraboard and 308duo

[flylow188]

When I plug in my EP Buddy 2S micro paraboard into my 308duo I get a voltage reading on cell 1 of around 1.45 volts with no batteries connected to the board. It even shows this with just the positive lead connected to the charger. I'm assuming it's from the charger trying to read cell voltages and getting a reading from the LED, a couple diodes, or protection fuses on the paraboard. It charges fine and the batteries show proper cell voltages when removed from the charger. I just want to make sure that this is OK for the charger and it's not something that might cause an issue later on like eventually frying something in the charger.

[RedOctobyr]

I'd take a look through this thread:
https://www.helifreak.com/showthread.php?t=625081

[flylow188]

Thanks Red. This also happens on my 1S board, shows a main voltage with no batteries. I might just stick to charging the small batteries with my X1.