START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
nano CP X Brushless Mods Blade nano CP X Brushless Mods Information and Help |
|
LinkBack | Thread Tools | Display Modes |
12-22-2012, 02:00 PM | #1 (permalink) |
Registered Users
Join Date: May 2006
|
can I?
So my brushed main motor spins constantly when plugged into the board. Can i use the small positive signal on the back of the board?
It seems like the negative point does not work. I am thinking it is cause the fet is bad? Sound ok? Thanks |
Sponsored Links | |||
Advertisement |
|
12-22-2012, 02:41 PM | #2 (permalink) |
Registered Users
Join Date: Jul 2011
Location: Colorado Springs
|
No, you will need an esc to drive a brushless motor to use that spot.
You might as well get a brushless kit as it is nearly the same price as a new 3in1. Or send it to megastumbler (megasmicros.com) and have him check out the board. He does amazing work.
__________________
Fusion 180 - M2 Evo - RAW 420 - Fusion 550 - Tron 5.5 - Kraken 580 - Kraken 580n - Kraken 700 - Kraken 700n - Vcontrol Evo |
12-22-2012, 03:15 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: May 2006
|
ok i was not specific. I have a brushless kit set to neg ppm. What i want to do is change it to postive and use the small point on the back. just making sur it is possible
|
12-22-2012, 04:33 PM | #4 (permalink) |
Registered Users
Thread Starter
Join Date: May 2006
|
Nevermind. I used another 3 in 1 i had and it is working great. This board has a missing resistor on the front. A bad motor fet and I think the pad in the back is lifted. Bought it used so not sure how much was already there.
I will either buy a new board or get this one fixed if someone is up to the task |
Thread Tools | |
Display Modes | |
|
|