Microbeast tail Question

[whaleboy]

Those of you using a Microbeast on a mini, how far out is the ball on your tail servo? I'm setting one up now and currently have it at 8.5mm but was wondering if I should bring it out a little.

Thanks

-David

[michael88997]

I have mine around 9 so yours is probably good, I would Try it first before moving it

[whaleboy]

Thanks. Flew this morning, pretty good with a little tweaking, only 4 flights. The tail is still a little on edge. On quick stops it was bouncing, after dropping the gain a bit and bringing down dial 3, it no longer bounces but it does stop, then does a continuation a little further (a few more degrees) then stops completely. So its kinda like hitting the brakes real hard, then as its just about to stop lifting up a bit.

Will try lowering the 3rd dial even more.

What settings are you guys using? Dials and tail gain. I've got mine set to transmitter mode and am running +15 expo in the tail and +20 on the cyclic.

-David