Register Now

Swashmix · 03-28-2009, 04:00 PM

Just setting up my HC Rigid with a JRX9303.
2 problems
In the diagnose window all stick movements are correct.
On the heli, collective pitch works fine.
The elevator and aileron movements on the head are reversed (elevator is being controlled by side to side and aileron is controlled by up and down). But they are all correct in the diagnose window.

My other problem is I am only getting rudder movement in one direction in heading hold.
Thanks in advance.

Gregg · 03-28-2009, 07:40 PM

I have the 3D version, but it's not completely hooked up yet, but I'm sure I remember reading that you could reverse those two channels. Just switch the two inputs and I believe it corrected everything.

merlin703 · 03-28-2009, 08:41 PM

THIS thread should have all answers to your questions.

Swashmix · 03-29-2009, 08:42 PM

Both problems fixed guys. Sometimes it takes a little problem to work through things and really make you understand the programming for troubleshooting within the system.
Thanks for the leads!

03-28-2009, 04:00 PM	#1 (permalink)
Swashmix Registered Users My HF Map location Join Date: May 2008	Helicommand setup questions Just setting up my HC Rigid with a JRX9303. 2 problems In the diagnose window all stick movements are correct. On the heli, collective pitch works fine. The elevator and aileron movements on the head are reversed (elevator is being controlled by side to side and aileron is controlled by up and down). But they are all correct in the diagnose window. My other problem is I am only getting rudder movement in one direction in heading hold. Thanks in advance. __________________

03-28-2009, 08:41 PM	#3 (permalink)
merlin703 Registered Users Join Date: Jan 2008	THIS thread should have all answers to your questions. __________________ JR X9303 TREX 500, TREX450, Joker 3 (almost ready),Typhoon3D, EZ* FPV, Stryker (Acromaster and EZG still in box)

03-29-2009, 08:42 PM	#4 (permalink)
Swashmix Registered Users Thread Starter My HF Map location Join Date: May 2008	Both problems fixed guys. Sometimes it takes a little problem to work through things and really make you understand the programming for troubleshooting within the system. Thanks for the leads! __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-28-2009, 07:40 PM	#2 (permalink)
Gregg Registered Users My HF Map location Join Date: Jan 2009	I have the 3D version, but it's not completely hooked up yet, but I'm sure I remember reading that you could reverse those two channels. Just switch the two inputs and I believe it corrected everything.

Register Now

Log-in